Suggestions and Tricks for Curtain Track Installation

We don’t mean to toot our own horn, however we’ve been doing this curtain track thing for a while now, and we’re pretty good at it. Over the years we now have realized many lessons about the most effective ways to put in curtain tracks. Many of our prospects are staunch do-it-yourselfers, which we applaud. Allow us to avoid wasting you some trial and error by sharing a few of the most useful ideas and tricks we’ve collected.

GETTING STARTED

Virtually any curtain track set up project can be achieved with a drill, miter or hack noticed, screw driver, tape measure, and level. In the event you’ve bought these on hand, the next step is to recollect some suggestions which might be helpful for any project: ask for help; and measure twice, minimize once.

SEEING IS BETTER THAN VISUALIZING

Earlier than you cut a track or drill a gap – lay everything out on the floor in entrance of you. Take note of the relative positions of the curtain track, drapery hardware, and curtain panels. Consider how the curtains will stack, where they’ll hit the top of the track, the general length of the curtain panels, and the space between panel and floor. Adjust as needed by way of hook position or tape height.

KEEP YOUR DISTANCE

We don’t care what you use to measure the gap from the ceiling to your wall-mounted bracket – so long as you employ the same thing for every bracket. So seize your level, ruler, block of wood, no matter – just use it consistently. Do the identical for keeping a constant distance from the wall and your ceiling-mounted track.

GLIDE IN FIRST

Trust us on this one – when using hooks in your curtains, put your carriers or glides onto the curtain track before the track is placed on the ceiling or wall. Should you’ve received a snap tape system, snap the carriers onto the curtain and then slide the carriers into the track.

SPLICE AND DICE

When splicing tracks collectively, use the factory-minimize sides for splicing, slightly than the hand cut. We’re certain you’re a fair hand with your miter saw, but the factory minimize end is bound to be sq. and can facilitate a greater joint.

When you loved this short article and you would want to receive much more information relating to curtain track ceiling mount kindly visit the web site.

Leave a Reply