Ideas and Tricks for Curtain Track Installation

We don’t mean to toot our own horn, but we’ve been doing this curtain track thing for a while now, and we’re fairly good at it. Over the years we now have realized many lessons about one of the best ways to install curtain tracks. A lot of our customers are staunch do-it-yourselfers, which we applaud. Allow us to avoid wasting you some trial and error by sharing a few of the most helpful tips and tricks we’ve collected.

GETTING STARTED

Nearly any curtain track set up project could be achieved with a drill, miter or hack noticed, screw driver, tape measure, and level. For those who’ve received these readily available, the next step is to remember some tips that are helpful for any project: ask for help; and measure twice, reduce once.

SEEING IS BETTER THAN VISUALIZING

Earlier than you cut a track or drill a hole – lay everything out on the floor in entrance of you. Take note of the relative positions of the curtain track, drapery hardware, and curtain panels. Consider how the curtains will stack, the place they’ll hit the top of the track, the general size of the curtain panels, and the house between panel and floor. Adjust as wanted by way of hook position or tape height.

KEEP YOUR DISTANCE

We don’t care what you use to measure the gap from the ceiling to your wall-mounted bracket – as long as you employ the identical thing for each bracket. So seize your level, ruler, block of wood, no matter – just use it consistently. Do the same for keeping a constant distance from the wall and your ceiling-mounted track.

GLIDE IN FIRST

Trust us on this one – when using hooks in your curtains, put your carriers or glides onto the curtain track before the track is placed on the ceiling or wall. In case you’ve obtained a snap tape system, snap the carriers onto the curtain after which slide the carriers into the track.

SPLICE AND DICE

When splicing tracks together, use the factory-minimize sides for splicing, moderately than the hand cut. We’re positive you’re a good hand with your miter saw, however the factory reduce end is bound to be sq. and will facilitate a better joint.

In case you have virtually any inquiries relating to wherever and also how you can utilize ceiling track for curtains, you are able to contact us from the web page.

Leave a Reply